Popsicles- Full Set

Add some whimsy charm to your clay creations with these variety of Popsicles cutters! This set features several different popsicles, perfect for layering, stud packs and more! 

Each set includes:

• 5 Large Cutters, 5 small cutters OR opt for both sets. 
• Clay cutters will vary depending on PLA colors on hand. 

Choose from:

• Large set, small set or both! Single popsicles are also available for purchase on my site if you prefer (or need to replace) just one set. 

Cutter details:

• Large: Approx. 45mm tall (about 1.7”)
• Small: Approx. 30mm tall (1.2”)
• Cutting depth:~2mm for large (recommended clay thickness 3.5-4mm) ~1.5 mm for small (Recommended clay thickness: ~2-2.5mm)
• Made with a sharp, beveled 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight