Popsicles- SINGLE purchase

Add some whimsy charm to your clay creations with these variety of Popsicles cutters! These are perfect for summer and the  different popsicles are perfect for layering, stud packs and more! 

Choose from:

• 5 large popsicles 
• 5 small popsicles 
• Full sets can be purchase at a discount on my site as well. 

Cutter details:

• Large: Approx. 45mm tall (about 1.7”)
• Small: Approx. 30mm tall (1.2”)
• Cutting depth:~2mm for large (recommended clay thickness 3.5-4mm) ~1.5 mm for small (Recommended clay thickness: ~2-2.5mm)
• Made with a sharp, beveled 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight