Cute Monster Builder Clay Earring Cutters

 Get creative with the Cute Monster cutter set—a must-have for fans of this mischievous little character! Start with the basic Monster body cutter, then mix and match with a variety of expressive faces and fun costumes to build your own custom versions. Whether you're crafting earrings, charms, or collector pieces, this set brings endless character and charm to your clay creations.

Choose from:

• The basic body
• costumes
• 3 expressive faces
• PLA color may vary depending on availability

Cutter details:

• Characters are ~40 mm when assembled
• Cutting depth: ~2 mm (Recommended clay thickness: ~3.5-4mm)
• Made with a sharp, 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight