Fairy Frog Earrings Kit

Are you new to polymer clay or earrings making? This kit is great for beginners and includes a lot of items you need to start out! 

Each set includes:

• 1 polymer clay cutter set (mirrored fairy frogs)
• 1 set of 2.5mm depth caps. You WILL need an acrylic roller, these snap on the ends so you can roll your clay out to your desired depth. 
• 1 set of earring hardware. 2 fish hooks snd 2 jump rings. 
• 1 block of olive clay
• 1 set of instructs and youtube video!

Cutter details:

• Approx. ~40mm
• Cutting depth: ~1.5 mm (Recommended clay thickness: ~2-2.5mm)
• Made with a sharp, beveled 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Snap on your depth caps. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.
6. After clay has cooled you can paint! I recommend using model paint, really good scratch resistant and it goes on so smooth. 

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight