Halloween Ball Clay Earring Cutters

Bring spooky season to life with these Halloween ball scene cutters! This set includes a round base “ball” cutter plus mini cutters—a haunted house, crescent moon, and ghost—so you can build your own eerie little scene inside. Perfect for layered earrings, ornaments, or detailed statement pieces with a ghostly twist. A must-have for Halloween-loving makers!

Choose from:

• 5 different sizes
• PLA color may vary depending on availability

Cutter details:

• Choose from 25, 30, 35, 40 or 45 mm
• Each set included the ball, moon, ghost and haunted house cutters. 
• Cutting depth: ~2 mm (Recommended clay thickness: ~3.5-4mm)
• Made with a sharp, 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight