Skip to product information
1 of 2

Skeleton Builder Clay Earring Cutters

Skeleton Builder Clay Earring Cutters

Regular price $10.00 USD
Regular price Sale price $10.00 USD
Sale Sold out
Shipping calculated at checkout.
Size

 

Meet your new spooky sidekick—the skeleton builder cutter set! Each bone is a separate piece, designed to be connected with jump rings so you can create a fully connected skeleton. Perfect for bold Halloween earrings, keychains, or charms with creepy-cute personality. Assemble it your way and bring this bony buddy to life!

Choose from:

  • 4 different sizes
  • these will be LARGE when fully assembled- perfect for the bold earring loving girlies! 
  • PLA color may vary depending on availability

Cutter details:

  • Choose from 70, 80, 90 and 100 mm (between 2.75-4inches) 
  • Cutting depth: ~2 mm (Recommended clay thickness: ~3.5-4mm)
  • Made with a sharp, 0.4mm edge for clean cuts and minimal cleanup

 

How to Use:

  1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
  2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
  3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
  4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
  5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

 

Care Instructions:

  • Rinse  with warm water only
  • Do not soak and avoid soap, as it can break down PLA over time
  • Store in a cool, dry place away from direct sunlight
View full details