Zero Clay Earring Cutters

Bring a little mischief to your clay creations with these Zero cutters! Perfect for fans of spooky season and The Nightmare Before Christmas, these cutters feature a cute design that capture the spirit of Halloween all year long. Whether you're crafting playful studs or statement dangles, these cutters add just the right touch of wicked charm.

Choose from: 

• Style: Choose a single cutter or a mirrored set for perfect symmetry
•  Sizes Available: 25,30,35,40 or 45 mm
• PLA color may vary depending on availability

Cutter details:

• Choose from 5 sizes
• Cutting depth: ~2 mm (Recommended clay thickness: ~3.5-4mm)
• Made with a sharp, 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight